Preparations
Inserting the Bobbin
Use only the bobbins designed for your creative
icon™ machine.
1. Open the bobbin cover by pushing the release button
(A) to the right. Remove the cover.
2. Place the bobbin in the bobbin case. It drops in only
one way with the logo facing up. The bobbin will
then rotate counterclockwise when you pull the
thread.
3. Place your finger on the bobbin to keep it from
turning as you pull the thread firmly to the right and
then to the left into the tension spring (B) until it
“clicks” into place. Continue threading around (C)
and to the right of the thread cutter (D).
4. Replace the bobbin cover. Pull the thread to the left
to cut.
44
To Next Page
Loading...
