Pfaff creative icon User Manual

Preparations
Attaching the Dynamic Spring Foot
6D
1. Disengage the IDT™ system.
2. Remove the standard presser foot.
3. Carefully loosen the screw until the cross-hole of the
presser foot holder is accessible.
4. Hold the foot in front of the needle. Turn the hand
wheel to lower the needle into the hole of the foot
and through the needle plate.
5. Turn the foot behind the needle screw and insert the
pin of the foot into the cross-hole of the presser foot
holder.
6. Push the foot into the hole as far as it will go while
tightening the screw.
To remove the embroidery foot loosen the screw,
squeeze the embroidery foot together and pull it out to
the right. Tighten the screw.
1
2
3
4
5
6
48

Pfaff creative icon Specifications

General

Stitch Width	9 mm
Needle Positions	37
Lighting	LED
USB Port	Yes
Automatic Thread Cutter	Yes
Built-in Memory	Yes
Maximum Sewing Speed	1050 stitches per minute
Connectivity	WiFi, USB
Needle Threader	Fully Automatic
Bobbin Winding	Separate bobbin winding motor
Screen	10.1" Full Color Touch Screen
Weight	15.6 kg