Sewing
Automatic Presser Foot Lift
When selected, the machine automatically raises the
presser foot in the following situations:
• When stopping with the needle in down position the
presser foot will automatically raise to pivot height.
• After a thread cut the presser foot will be raised to lift
position.
When deselected, the presser foot will stay lowered,
even if the machine stops with the needle in down
position.
Automatic Thread Cutter
When selected, the threads are cut automatically in the
following situations:
• At cut commands in stitches and sequences.
• After sewing a single stitch e.g. a monogram or
eyelets.
If deselected, no automatic thread cut will be performed.
Note: Deselect when using optional accessories that are
attached in the two holes in the needle plate just above the
bobbin cover, to prevent damage to the automatic thread
cutter knife located under the needle plate.
Free-Motion Options
Free-Motion Options
All stitches on your machine can be sewn in free-motion
mode to create fantastic effects. You can select between
three different Free-Motion Options. For all free-motion
sewing the Feed Dogs will lower automatically and the
fabric must be moved manually.
Free-Motion Options are accessible both in Settings and
if you touch Free-Motion icon in Sewing Mode. Your
Temporary Settings are shown under Active features in
the Information Area.
Note: Make sure that the IDT™ system is disengaged.
86
To Next Page
Loading...
Need help?
General
