Introduction
Presser Feet
Note: For the best sewing results, use only presser feet
designed for and compatible with your creative icon™
machine.
OA -Standard Presser Foot for IDT™ System
(attached on the machine upon delivery)
This foot is used mainly for straight stitching and zigzag stitching with a stitch
length longer than 1.0 mm.
1A - Fancy Stitch Foot for IDT™ System
This foot is used for decorative stitches. The groove on the underside of the foot
is designed to flow smoothly over the stitches.
2A - Fancy Stitch Foot
When sewing decorative stitches or short zigzag stitches and other utility
stitches with less than 1.0mm stitch length, use this foot. The groove on the
underside of the foot is designed to flow smoothly over the stitches.
3 – Blindhem Foot for IDT™ System
This foot is used for blindhem stitches. The toe on the foot guides the fabric. The
red guide on the foot is designed to ride along the fold of the hem edge.
4 – Zipper Foot for IDT™ System
This foot can be snapped on either the right or the left of the needle, making it
easy to sew close to both sides of the zipper teeth. Move needle position to right
or left to sew closer to zipper teeth.
5A – Sensormatic Buttonhole Foot
When connected to the machine, the buttonhole is sewn in the length that has
been entered into the machine.
5M - Manual Buttonhole Foot
This foot is used for sewing manual buttonholes. Use the markings on the foot
to position the garment edge. The finger on the back of the foot holds cording
for corded buttonhole.
6A – Embroidery/Sensormatic Free Motion Foot
This foot is used for embroidery and free motion sewing. This foot can also be
used for darning.
6D - Dynamic Spring Foot
This foot is always recommended for embroidery. It is also used for free motion
sewing, quilting and embroidering on especially thick or spongy fabric. When
using the Dynamic Spring Foot for free motion, select Dynamic Spring Foot Free
Motion setting in the Free Motion Options window in Sewing Mode.
19
To Next Page
Loading...
Need help?
General
