Embroidery Preparations
To Hoop the Fabric
For the best embroidery results, place a layer of
stabilizer beneath the fabric. When hooping stabilizer
and fabric make sure that they are smooth and securely
hooped.
1. Open the quick release (A) on the outer hoop and
loosen the screw (B). Remove the inner hoop. Place
the outer hoop on a firm flat surface with the screw
on the lower right (B). There is a small arrow in the
center of the lower edge of the hoop which will line
up with a small arrow on the inner hoop.
2. Place the stabilizer and fabric, with the right sides
facing up, on top of the outer hoop. Place the inner
hoop on top of the fabric with the small arrow at the
bottom edge. If you can see the hoop size in the
lower part of the inner hoop, you have attached it
correctly.
3. Push the inner hoop firmly into the outer hoop.
4. Close the quick release (A). Adjust the pressure of
the outer hoop by turning the retaining screw (B).
The fabric should be taut in the hoop for the best
results.
Note: When embroidering additional designs on the same
fabric, open the quick release, move the hoop to the new
position on the fabric and close the quick release. When
changing type of fabric, you might need to adjust the pressure
using the retaining screw. Do not force the quick release.
Slide on/off the Hoop
Slide the hoop connector into the hoop attachment (A)
from front to back until it clicks into place.
To remove the hoop from the embroidery arm, press the
grey button (B) on the hoop attachment and slide the
hoop towards you.
53
To Next Page
Loading...
Need help?
General
