Preparations
3 Preparations
Unpacking Machine and
Embroidery Unit
After lifting the machine out of the box and removing
all packing material and the plastic bag, wipe the
machine, particularly around the needle and needle
plate to remove any oil before sewing.
When unpacking the embroidery unit, do not throw
away the black styrofoam inside the embroidery unit
carrying bag, as this is designed for storing the
embroidery unit when not in use.
Note: Your creative icon™ machine is adjusted to provide
the best stitch result at normal room temperature. Extreme
hot and cold temperatures can affect the sewn results.
When removing the embroidery unit from the box
for the first time, be sure to remove the shipping
brace (A) on the underside of the embroidery unit.
Connect the Power Cord and Foot
Control
Among the accessories you will find the power cord and
the foot control.
Note: Before plugging in the foot control, check to ensure that
it is type "FR5" (see underside of foot control).
1. Pull out the cord from the foot control. Connect the
foot control cord to the front socket on the bottom
right side of the machine.
2. Connect the power cord to the rear socket on the
bottom right side of the machine. Plug the cord into
the wall socket.
3. Press the ON/OFF switch to "I" to turn on power
and light.
For the USA and Canada
This sewing machine has a polarized plug (one blade
wider than the other). To reduce the risk of electric
shock, this plug is intended to fit in a polarized outlet
only one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet. Do
not modify the plug in any way.
26
To Next Page
Loading...
Need help?
General
