Embroidery Preparations
Connect the Embroidery Unit
1. Slide the accessory tray off.
2. Slide the embroidery unit onto the free arm of the
machine until it plugs firmly into the socket at the
back of the machine. If needed, use the level
adjusting feet so that the machine and embroidery
unit are even. If the machine is turned off, turn it on.
3. If you were already in embroidery mode or when
you switch to embroidery mode, a pop-up message
tells you to clear the embroidery arm and remove
the hoop before calibration. Touch OK. The machine
will calibrate and the embroidery arm will move to
the ready position.
Note: DO NOT calibrate the machine with the embroidery
hoop attached as this can damage the needle, presser foot, hoop
and/or the embroidery unit. Be sure to clear all materials from
around the machine before calibrating so that the embroidery
arm does not bump into anything while calibrating.
Remove the Embroidery Unit
1. To store the embroidery unit in the embroidery case,
move the embroidery arm to park position. See park
position in the built-in user’s guide.
2. Press the button at the left, underneath the
embroidery unit (A) and slide the unit to the left to
remove it.
3. Store the embroidery unit in the original black
styrofoam packing material, placed in the soft
carrying bag.
52
To Next Page
Loading...
Need help?
General
