Shape Creator
Positioning
Touch the Positioning icon in Shape Creator, to open the
Positioning control window to make adjustments to
your shape.
Control Points
1. Selected control point marked with a filled square
2. Unselected control point marked with an outlined square
A control point is a point affecting the selected shape.
Each shape is built by several control points. Together
they define what the shape will look like.
A selected control point is marked with a filled square.
An unselected control point is marked with an outlined
square. All control points are visible when you are
editing the points. By adjusting the control points, the
selected shape can be changed with unlimited
possibilities.
Select Control Points
For each shape, there are pre-defined sets of control
points. Select all or some of the control points.
When you have selected a set of control points, you can
make adjustments to the shape: move, rotate and scale.
The adjustments made will only affect the selected
control points.
Use the slider to increase or decrease the attraction
percentage of the selected control points. The higher the
attraction percentage, the closer the baseline will be to
the selected control points.
158
To Next Page
Loading...
Need help?
General
