Embroidery Edit
Settings in Embroidery Edit
1. Default Settings in white colored check boxes
2. Temporary Settings in orange colored check boxes
There are two ways to change your settings;
1. Default Settings:
Settings made in Default Settings will be saved, even
when turning your machine off. The default setting
becomes active when you start a new session or
restart your machine.
2. Temporary Settings:
Settings made in Temporary Settings will be reset at
the start of a new project in Help Center or start of a
new sewing session. When turning your machine off,
all changes made in Temporary Settings will be reset
to default.
Changes made in Temporary Settings are shown under
Active Features in the Information Area.
ActivStitch™ Technology
When the ActivStitch™ technology feature is selected
your creative icon™ will automatically choose the best
way to control the embroidery upper thread based on
the design and the selected settings: thread metering or
thread tension. For best embroidery results we strongly
recommend that you keep this setting selected and
select the spring foot for embroidery foot type.
When the ActivStitch™ technology feature is selected
thread metering will be used when the spring foot is
selected as the embroidery foot unless e.g. the active
color block indicates a felting color block or a cutwork
needle color block in the color block list.
When the ActivStitch™ technology feature is deselected
and/or embroidery foot type is set for floating foot,
thread tension will be used for all designs and settings.
For some specific special techniques and accessories that
cannot be embroidered with thread metering, the
ActivStitch™ technology feature needs to be deselected.
125
To Next Page
Loading...
Need help?
General
