Embroidery Edit
Embroidery Foot Type
Dynamic Spring Foot 6D Free-Motion
Sensormatic Free-Motion Foot 6A
Select either the Dynamic Spring Foot 6D Free-Motion
or a Sensormatic Free-Motion Foot, e.g. 6A. It is very
important that the correct setting is selected for the
attached embroidery foot.
Embroidering with theActivStitch™ technology feature
and the Dynamic Spring Foot 6D is needed for good
embroidery results.
Some specific specialty techniques and/or accessories
do not support the use of the Dynamic Spring Foot 6D, e.
g. yarn couching and felting.
When the Dynamic Spring Foot 6D is selected the
machine will lower the foot to hold the fabric at each
stitch. When a sensormatic foot is selected the machine
will lower the foot to a pivot height above the fabric.
When using a sensormatic foot the presser foot height
can be adjusted for improved performance when using
different weights of material and/or embroidery
threads.
Note: The embroidery foot will be reset to Dynamic Spring
Foot 6D at the start of a new project or start of a new
embroidery session from the start page. Make sure you attach
the correct foot or change the setting.
Twin Needle Options
Twin Needle Options
When a twin needle size is selected the ActivStitch™
technology feature will automatically use thread tension.
When embroidering with a twin needle the Straight
Stitch Needle Plate needs to be removed as it cannot be
used with a twin needle.
Note: It is very important to activate the twin needle setting
when embroidering with a twin needle to prevent damage to
the machine.
126
To Next Page
Loading...
Need help?
General
