Index
Page Page
Final assembly ....................02-030-55 Fuel supply pump drive pin, replace ......02-050-18
Fuel system .........................02-090-1Lifting ............................02-010-4
Mounting engine onto repair stand ......02-010-6 Fuel system theory of operation .........03-120-10
Oil consumption ...................04-150-10
Operation, theory of .................03-120-1
Option code label ...................01-001-3
Overhaul guidelines .................02-010-1
G
Preliminary testing before tune-up......02-010-22
Repair stand .......................02-010-1
Grease
Repair stand adapters................02-010-3
Extreme pressure and multipurpose .....01-002-9
Sealants .........................02-010-11
Serial number plate..................01-001-2
Engine adapter, repair stand ............02-010-3
Engine crankcase pressure (blow-by)
H
check ...........................04-150-12
Engine oil
Head gasket
Break-In ..........................01-002-4
Check for failure ...................04-150-17
Diesel ....................01-002-5, 01-002-6
Construction ......................03-120-11
Extended Service Intervals ............01-002-7
Failure analysis....................02-020-17
Engine oil pressure check .............04-150-11
Exhaust air leak check ................04-150-22
Exhaust and air intake system
specifications .....................06-200-23
I
Exhaust manifold
Remove, inspect and install ..........02-080-18
Inch torque values ....................06-200-2
Exhaust restrictions check .............04-150-20
Injector
Exhaust system
Adjust preload......................02-020-4
Operation, theory of ................03-120-12
Intake air leak check .................04-150-21
Exhaust system, check................02-010-18
Intake and exhaust system
Check for restrictions ...............04-150-20
Indx
Operation, theory of ................03-120-12
3
Intake manifold
F
Remove, inspect and install ..........02-080-21
Intake manifold pressure (turbo boost)
Fan drive bearings, replace .............02-070-1
Measure .........................04-150-19
Flywheel
Intake restrictions check...............04-150-20
Inspect ...........................02-040-9
Install ...........................02-040-12
Measure flatness....................02-040-8
Remove ..........................02-040-8
L
Replace ring gear ..................02-040-10
Flywheel housing
Measure face runout.................02-040-7 Lubricant
Mixing............................01-002-8Remove .........................02-040-11
Front crankshaft oil seal Lubrication system
DiagnosticsInstall ...........................02-040-39
Remove ..........................02-040-5 Engine oil pressure high ............04-150-5
Engine oil pressure low .............04-150-6Front plate
Remove and install ..................02-030-1 Excessive oil Consumption ..........04-150-2
Flow diagram ......................03-120-4Front timing gear backlash, adjust ........02-050-4
Fuel Operation, theory of .................03-120-4
Specifications .....................06-200-19Diesel ....................01-002-1, 01-002-2
Lubricity ..........................01-002-3 Lubricity of diesel fuel..................01-002-3
CTM100 (06APR04)
Index-3
P
OWER
T
ECH
10.5 L & 12.5 L Diesel Engines
040604
PN=3
To Next Page
Loading...