Index
Page Page
M
Piston spray jets, remove and install .....02-030-54
Pistons
Disassemble pistons and rods ........02-030-20Main bearings
Failure analysis....................02-040-15 Inspect compression ring groove
(6105) .........................02-030-22Inspect thrust bearings ..............02-040-27
Install ...........................02-040-28 Inspect compression ring groove
(6125) .........................02-030-23Measure .........................02-040-22
Measure caps .....................02-040-23 Inspect oil control ring groove .........02-030-24
Inspect pin and bore ................02-030-25Oil clearance......................02-040-18
Remove .........................02-040-16 Measure protrusion .................02-030-53
Pins and bushings, inspect ...........02-030-34Thrust bearing new part
specifications....................02-040-27 Piston pin bushing, install ............02-030-37
Piston-to-liner clearance, measure .....02-030-26Metric torque values ...................06-200-3
Mixing lubricants......................01-002-8 Preliminary checks ..................02-030-5
Remove piston pin bushings and clean
bore...........................02-030-36
O
Oil consumption, excessive .............04-150-2
R
Oil cooler
Exploded view......................02-060-1 Rear oil seal and housing
Install housing.....................02-040-32Remove, clean and inspect............02-060-6
Oil cooler and oil filter bypass valves, remove, Install oil seal and wear sleeve ........02-040-33
Remove .........................02-040-13inspect and install ...................02-060-4
Oil filter adapter, inspect and replace ......02-060-2 Rocker arm assembly
Assemble ........................02-020-23Oil filter and housing/oil cooler cover and valve
housing Check and adjust clearance and
preload .........................02-020-4Exploded view......................02-060-1
Install ............................02-060-8 Disassemble and inspect ............02-020-21
Install ...........................02-020-61Remove ..........................02-060-2
Oil pan Remove .........................02-020-10
Rocker arm coverInstall ...........................02-060-15
Remove .........................02-060-13 Gasket replace .....................02-020-3
Indx
4
Oil pickup tube, remove and install.......02-060-14 Remove and install ..................02-020-1
Oil pressure check ...................04-150-11
Oil pressure high .....................04-150-5
Oil pressure low ......................04-150-6
S
Oil pressure regulating valve, remove, inspect and
install ............................02-060-3
Safety precautions, repair stand
Oil pressure relief valve, remove, inspect and
mounting..........................02-010-2
install ............................02-060-5
Sensor
Oil pump
Crankshaft position sensor depth
Clean and inspect pump and drive
check..........................04-150-24
gear...........................02-060-11
Service Intervals
Install ...........................02-060-12
Extended Diesel Engine Oil ...........01-002-7
Remove .........................02-060-10
Specifications
Air intake and exhaust system ........06-200-23
Camshaft and timing gear train........06-200-17
Cooling system ....................06-200-21
P
Crankshaft, main bearings and
flywheel ........................06-200-14Piston pins and bushings
Remove bushings and clean bore......02-030-36 Cylinder block, liners, pistons and rods. . .06-200-9
CTM100 (06APR04)
Index-4
P
OWER
T
ECH
10.5 L & 12.5 L Diesel Engines
040604
PN=4
To Next Page
Loading...