R&S FSPN - Page 106

Common Measurement Settings
R&S
®
FSPN
106User Manual 1179.4363.02 ─ 01
The auto search features are available for phase noise measurements.
The remote commands required to configure the frequency are described in Chap-
ter 11.6.5, "Remote Commands to Configure the Frequency", on page 356.
Defining the signal frequency......................................................................................106
Searching for a signal................................................................................................. 107
Capture Range............................................................................................................108
Defining the measurement range................................................................................108
Measuring low frequency and low level signals.......................................................... 108
└ Low signal frequencies................................................................................. 109
└ Low signal levels...........................................................................................109
└ Multicarrier signals........................................................................................ 110
Defining the signal frequency
The "Signal Frequency" is the frequency the signal is transmitted with.
You can define it manually in the corresponding input field or let the R&S FSPN search
for the signal frequency in an automatic frequency search (turn on the "Auto Search" in
that case).
Not available for baseband noise measurements.
Frequency