R&S FSPN - Page 273

Network and Remote Operation
R&S
®
FSPN
273User Manual 1179.4363.02 ─ 01
Bit No. Meaning
2 LMARgin 3 FAIL
This bit is set if limit margin 3 is violated.
3 LMARgin 4 FAIL
This bit is set if limit margin 4 is violated.
4 LMARgin 5 FAIL
This bit is set if limit margin 5 is violated.
5 LMARgin 6 FAIL
This bit is set if limit margin 6 is violated.
6 LMARgin 7 FAIL
This bit is set if limit margin 7 is violated.
7 LMARgin 8 FAIL
This bit is set if limit margin 8 is violated.
8 to 14 Not used
15 This bit is always 0.
STATus:QUEStionable:POWer Register
The STATus:QUEStionable:POWer register contains information about possible
overload situations that may occur during operation of the R&S FSPN. A separate
power register exists for each active channel.
You can read out the register with STATus:QUEStionable:POWer:CONDition? or
STATus:QUEStionable:POWer[:EVENt]?
STATus:QUEStionable:POWer:DCPNoise
Available for the phase noise application.
The STATus:QUEStionable:POWer:DCPNoise register contains information about the
state and condition of the DC power supply. A separate POWer:DCPNoise register
exists for each active channel.
You can read out the register with STATus:QUEStionable:POWer:DCPNoise:
CONDition? or STATus:QUEStionable:POWer:DCPNoise[:EVENt]?.
Table 10-14: Meaning of the bits used in the STATus:QUEStionable:POWer:DCPNoise register
Bit No. Meaning
0 V
supply
/ I
supply
This bit is set if something is wrong with the voltage or current supply.
1 V
tune
This bit is set if something is wrong with the tuning voltage supply.
2 V
aux
This bit is set if something is wrong with the auxiliary voltage supply.
Remote Control Basics