R&S FSPN - Page 274

Network and Remote Operation
R&S
®
FSPN
274User Manual 1179.4363.02 ─ 01
Bit No. Meaning
3 to 14 Unused
15 This bit is always 0.
STATus:QUEStionable:PNOise
Available for the phase noise application.
The STATus:QUEStionable:PNOise register contains information about the state and
condition of the phase noise application. A separate PNOise register exists for each
active channel.
You can read out the register with STATus:QUEStionable:PNOise:CONDition?
on page 516 or STATus:QUEStionable:PNOise[:EVENt]? on page 517.
Table 10-15: Meaning of the bits used in the STATus:QUEStionable:PNOise register
Bit No. Meaning
0 Unused
1 SIGNal not found
This bit is set when no signal could be found during the signal search.
2 Unused
3 to 14 Unused
15 This bit is always 0.
STATus:QUEStionable:TEMPerature Register
The STATus:QUEStionable:TEMPerature register contains information about possible
temperature deviations that may occur during operation of the R&S FSPN. A separate
temperature register exists for each active channel.
You can read out the register with STATus:QUEStionable:TEMPerature:
CONDition? or STATus:QUEStionable:TEMPerature[:EVENt]?
Table 10-16: Meaning of the bits used in the STATus:QUEStionable:TEMPerature register
Bit No. Meaning
0 This bit is set if the frontend temperature sensor deviates by a certain degree from the self-
alignment temperature.
During warmup, this bit is always 1.
1 to 14 Unused
15 This bit is always 0.
STATus:QUEStionable:TIMe Register
The STATus:QUEStionable:TIMe register contains information about possible time
errors that may occur during operation of the R&S FSPN. A separate time register
exists for each active channel.
Remote Control Basics