15-6 Replacing or Exchanging Drive Components ECODRIVE03 Drive Controllers
Pi6005f1.fh7
Barcode
0
1
2
3
4
5
6
7
8
9
0
1
2
3
4
5
6
7
8
9
H1
S1
S3 S2
Barcode
Typenschild
123 4 5 6 7 8 9 1 2 3 4
11121314 15161718
567 8
123 4
123 4
567 8
:etaD:.oC Loc.:
:.leT:.tpeD Name:
S. No.:
Motor type:
Info about motor:
Fault Report
for digital AC Servo Drives DKC
H1
DKC _ _._ - _ _ _ - _
S.N.: _ _ _ _ _ _ -_ _ _ _ _
Hardware-
S.N._ _ _ _ _ _ - _ _ _ _ _
Software-
S.N._ _ _ _ _ _ - _ _ _ _ _
FWA-ECODR3-_ _ _-_ _ VRS
X5 DC bus connection
mains connection:
single phase
three-phase
This fault report is intended to clarify problems and their causes. It is absolutely necessary for nding and eliminating
hidden, sporadic or application-related problems.
- Always include a Fault report with any parts returned for repair.
- Otherwise, send Fault Reports to your Rexroth Indramat representative
Fault Report
dated:
Information about the drive
:
Data on rating plate
Enter
display
data at
time
problem
occurred
Information about machine at which problem occurred:
Describe the problem:
Machine manuf.:
Machine number:
:sruoh .repO:epyT
Comm. date:
Manufacturer and type of machine control:
Designation of the machine axis in which fault occurred:
Addition
al data:
Problem
:
Causes
:
Auxiliary problems:
always present
at startup
occurs sporadically
occurs after hrs.
with vibrations
depends on temperature
unknown
incorrect connection
external cause
mechanical damage
loose cable connection
moisture in unit
foreign object in unit
problem in the mechanical system
power section failure
control system failure
motor failure
cable break
defective blower
defective feedback
Is there an air conditioner
in the cabinet ? Y / N
Have there been previous
problems at this machine ?
How often:
Did the problems occur on the same day or
the same time of the day ?
Additional data:
Fig. 15-3: Fault report
customerservice@hyperdynesystems.com | (479) 422-0390
To Next Page
Loading...
Need help?
General
