RFL 9780 RFL Electronics Inc.
April 8, 2003 xix (973) 334-3100
REVISION RECORD
Rev. Description Date Approval
6-29-99 New Document Release
08/03/99 CS
10-12-99 Revised in accordance with new design information
11/03/99 CS
03-10-00 Revised in accordance with ECO No. 9780-005, 014, 016,
017, 021, 023, 034
06-26-00 CS
05-19-00 Revised in accordance with RFA No. 7288.
Revised in accordance with ECO No. 9780-004, 007, 045.
Revised in accordance with ECO No. 9785-012, 026. Added
Section 7 on Tx Logic Module.
02-16-01 CS
11-01-00 Revised in accordance with ECO No. 9780-050, 058, 060,
065, 067
Revised in accordance with RFA No. 6504.
03-09-01 CS
2-28-01 Added External Power Amp I/O to Section 17.
Added Dual Hybrid module to Section 18.
Added information on all five types of Mother Boards to
Section 20.
Revised in accordance with ECO No:
9780-064: (Added –5 to output filter schematic)
9780-079: (Revised SOE board, parts list & schematic)
07-16-01 CS
5-11-01 Revised in accordance with RFA No: 8006
Revised Receiver unblocking function logic
Added Figure 6-5 (Unblocking function timing diagram)
Revised in accordance with ECO No:
9780-081: (Added capacitor to power supply)
9780-082: (Revised I/O panel markings)
9780-086: (Clarified use of jumper J2)
9780-087: (Delete & replace U3, N/A R38, C42 & C43)
7-16-01 CS
9-8-01 Revised in accordance with ECO No:
9780-088: (Added LM/SL test points to Section 14)
9780-089: (Common PC board for all hybrids to Section 18)
9780-092: (Added “modules fully seated” warning label to
Section 0)
Revised Table 2-2 in Section 2
09-10-01 CS
01-10-02 Revised in accordance with ECO No:
9780-085: (Replaced SW1 with K1 on Output Filter
Module, Section 10)
01-10-02 CS
To Next Page
Loading...