RFL 9780 16 - 9 RFL Electronics Inc.
April 8, 2003 (973) 334-3100
055 - Freq Ch2 (Hz) This parameter is set to the Channel 2 transmit frequency. This parameter
is only used if parameter 056 is set to Y (yes), and is only applicable in a
TxTx chassis that has an X-hybrid installed in the Tx Channel 2 output
path.
056 - X Hybrid Ch2 This parameter is set to:
Y (yes) if an X-Hybrid is installed in the Channel 2 transmit path, or set
to
N (no) if an X-Hybrid is not installed in the Channel 2 transmit path.
This parameter is normally set at the factory, or can be set by the user.
100 - RxCh1 Level Indicates the Channel 1 receive level (+/-10 dB from nominal). This is the
same number that is displayed on the RFL 9780 front panel digital meter.
101 - RxCh2 Level Indicates the Channel 2 receive level (+/-10 dB from nominal). This is the
same number that is displayed on the RFL 9780 front panel digital meter.
102 - TxCh1 PWR(50ohm) Indicates the amount of power that would be transmitted into an ideal,
balanced 50Ω load, with zero reflection (with source and load matched),
for Channel 1. Typical range is 1W to 10W
103 - TxCh2 PWR(50ohm) Indicates the amount of power that would be transmitted into an ideal,
balanced 50Ω load, with zero reflection (with source and load matched),
for Channel 2. Typical range is 1W to 10W
104 - TxCh1 Actual PWR Indicates the actual power being transmitted into the load for Channel 1.
Theoretical range is 0W to 10W.
105 - TxCh2 Actual PWR Indicates the actual power being transmitted into the load for Channel 2.
Theoretical range is 0W to 10W.
106 - TxCh1 REFL PWR Indicates the Channel 1, percent reflected power. Numerical range is 0%
to 40%. Over 40% reflected power will be displayed as >40%.
If there is an open or short, “OPEN” or “SHORT” will be displayed.
107 - TxCh2 REFL PWR Indicates the Channel 2, percent reflected power. Numerical range is 0%
to 40%. Over 40% reflected power will be displayed as >40%.
If there is an open or short, “OPEN” or “SHORT” will be displayed.
To Next Page
Loading...