0: No
1: Yes. If “1” is selected, the customer will be able to input a non-standard paper size using
the UP mode.
5113 Optional Counter Type
001 Optional Counter Type 1 CTL
This program specifies the counter type.
0: None
1: Key card (RK 3, 4)
2: Key card (down)
3 to 10: (Japan only)
11: Exp. Key card (Add)
12: Exp. Key card (Deduct)
002 Optional Counter Type 2 CTL
This program specifies the external counter type.
0: None
1: Expansion Device type 1
2: Expansion Device type 2
3: Expansion Device type 3
5114 Optional Counter I/F CTL
[0: Not installed/ 1: Installed (scanning
accounting)]
001 MF Key Card Ext. Japan use
5118 Disable Copying CTL [0: Not disabled/ 1: Disabled]
001 This program disables copying.
5120* Clear For Count Remove [0=Yes / 1=Standby only / 2=No]
5120 1
Specifies the condition to reset the copy job settings when the key counter is removed.
• 0 = Yes: The settings are cleared when the counter is removed.
• 1 = Standby only: The settings are cleared when the counter is removed at the end of a
job.
• 2 = No: The settings are not cleared under either condition.
As for duplex copying, the job settings are always preserved regardless of these setting.
5. Service Tables
154
To Next Page
Loading...
