5121* Counter Up Timing [0 = Feed In / 1 = Exit]
5121 1
Selects the count-up timing.
• 0 = Feed: At each paper feed
• 1= Exit: At each paper exit
5150 By-pass Long Paper CTL [0 = OFF / 1 = ON]
001
Determines whether the transfer sheet from the by-pass tray is used or not.
Normally the paper length for sub scanning paper from the by-pass tray is limited to 600
mm, but this can be extended with this SP to 1260 mm.
5167
Fax PrintingCnt Off
Enables or disables the automatic print out without an accounting device. This SP is used
when the receiving fax is accounted by an external accounting device.
001 Fax Printing Counter Off CTL
[ 0 or 1 / 0 / – ]
0: Automatic printing
1: No automatic printing
5169
CE Login
If you change the printer bit switches, you must ‘log in’ to service mode with this SP before
you go into the printer SP mode.
001 CE Login CTL
[0 or 1 / 0 / - ]
0: Disabled
1: Enabled
5188 Copy NV Version
001 Copy NV Version CTL Displays the NVRAM version in the controller board.
5302
Set Time
Adjusts the RTC (real time clock) time setting for the local time zone.
Examples: For Japan (+9 GMT), enter 540 (9 hours x 60 min.)
DOM: +540 (Tokyo)
NA :-300 (New York)
Service Program
155
To Next Page
Loading...
