Rigol DM858 - Screen Image

NOTE
• To ensure the external trigger works normally, ensure that the period of the input trigger
signal is greater than the measurement period (1.6 s) when using external trigger in
measuring Frequency/Period.
• For other measurements, to ensure the effectiveness of the external trigger, ensure that
the period of the input trigger signal is greater than the measurement period (0.4 s).
• For Continuity, Diode, and Capacitance measurements, Auto trigger is fixed and cannot
be modified to other trigger types.
• In external trigger, when no external trigger is input, the instrument will stay Auto trigger
state when the trigger edge is high level until an external trigger signal is input.
5.9 Screen Image
To capture the screen image, perform either one of the following two operations.
Quick Save of Screen Image
Click or tap
> PrintScreen.
The system auto captures and saves the screen image of the current interface. The
image is saved in "*.png" format and cannot be modified to other formats. After
performing the operation, "C:/ScreenShot-hh-mm-ss.png" is displayed, indicating the
location of the saved image and its name. "hh-mm-ss" shows the time for capturing
the screen image. To set the information about the saved image, including its color,
header, storage path, refer to
To Save a File for details.
Save the Screen Image with Storage Operation
Press
on the front panel to enter the storage interface. You can also click or
tap > Storage to enter the storage interface.
Front Panel Operation
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved. DM858 Series User Guide
99