Rigol DM858 - Figure 5.79 Setup Saving

Click or tap the input field of File Path, then the disk management interface is
displayed. Select the desired destination storage directory, then click or tap OK
to set the storage path.
• Overlay
Click or tap the ON/OFF button for the
Overlay menu to enable or disable the
overwriting function. When enabled, the existing file in the specified file path will
be overwritten by the newly saved file that has the same filename as the existing
one.
• Save
Click or tap Save to save the current data file. Then the current data are saved
and the current saving interface exits automatically.
Setup Saving
In Figure 5.77 , click or tap the drop-down button of Type to select "Setup". The
setup parameter setting is displayed, as shown in the figure below.
Figure 5.79 Setup Saving
Saves the current system configurations.
• Format
Click or tap the drop-down button of
Format to select "*.sta" or "*.prf" from
the drop-down list. Then the system configurations will be saved to the internal
or external memory in the specified format.
The state file suffixed with "*.sta" stores the settings such as the current
measurement mode, measurement rate, range, math operation, and trigger
mode. The preferences file suffixed with "*.prf" stores the settings related to the
Front Panel Operation
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved. DM858 Series User Guide
113