4. Click or tap to enable or disable the relative operation function.
When enabled, the displayed reading value is the result obtained by subtracting
the set relative value from the actual measurement value. For the relative value
setting methods, refer to descriptions in "
Math Operation
".
5. Read the measured value
The frequency measurement is measured at a fixed "slow" rate with a 5.5-digit
display. Therefore, the reading rate cannot be adjusted during measurement
results reading.
6. Hold the reading data
Press
to run and hold the reading data displayed on the screen.
5.3.9.2 Measure Period
Operation Procedures:
1. To enter the period measurement interface, perform either one of the following
two operations.
- Press > on the front panel;
- Click or tap the main measurement item shown at the left part of the main
display area. The measurement items are displayed. Click or tap to select
to enter the period measurement interface.
Front Panel Operation
DM858 Series User Guide
54
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
To Next Page
Loading...
