Rigol DM858 - Page 34

When you press the 2ND key on the front panel, the "2ND" tab is highlighted.
9. "Run/Hold" Tab
Click or tap the "Run/Hold" tab to switch the status from Run to Hold. You can also
press Run/Hold on the front panel to switch the status from Run to Hold.
10. "Single" Tab
Click or tap the "Single" tab to initiate one single trigger. You can also press Single
on the front panel to initiate one single trigger.
11. Notification Area
Displays the USB storage device icon, LAN connection, sound icon, and remote
control icon. Click or tap the area, the system setting menu is displayed.
-
USB storage device icon: When a USB storage device is detected,
will be
displayed.
-
LAN connection icon: When the LAN interface is successfully connected, is
displayed.
- Sound icon: In the "System" menu, click or tap
Settings > Beeper to enable or
disable the sound. When the sound is turned on, will be displayed; when off,
will be displayed. Clicking or tapping the sound icon can also enable or
disable the sound.
- Remote control icon: When you control the instrument remotely,
will be
displayed.
- Time: When you enable to display the time information, the system time is
displayed.
12. Shortcut Menus
Provides four fixed shortcut menus (
Measure, Display, Math, and Trigger) and
two customized menus. You can click or tap to customize the shortcut menu
that you want to add here.
13. Function Navigation Icon
Click or tap the icon to enter the function navigation menu. Click or tap the
desired menu to enter the specified menu setting interface.
14. Main-Secondary Measurement Item Switchover Icon
When you enable the 2ND measurement, click or tap this icon to switch between
the main measurement item and the secondary (2ND) measurement item.
15. Secondary (2ND) Measurement Range
Displays the measurement range of the 2ND measurement item when the 2ND
measurement is enabled.
Quick Start
DM858 Series User Guide
22
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.