SATO E series - Page 40

SATO M-10e TT/DT Printers Service Manual
PN 9001098
Rev. A
2-16
Section 2. Configuration
LCD Panel —Advanced Mode
Set Calendar (Continued)
To enable the Calendar feature (if installed), use the keys to step the cursor to
either YES or NO. Press ENTER to confirm YES (Calendar setting: YES) or NO (Calendar
setting NO).
calendar
00/00/00 00:00
Calendar
00/00/00 00:00
STEP PROCEDURE
1. Pressing LINE and FEED keys simultaneuosly sets the date and time.
Use the keys to scroll through the settings and press ENTER to
confirm each item and return to the next screen. You will be able to set the
Year, Month, Day, Hour and Minute in sequence.
a. Year - The first display shown will have the cursor over the two digit year
selection. Scroll through the dates by pressing the LINE/FEED keys. The
year number will increase by one each time the LINE key is pressed until it
reaches its maximum legal value, (i.e., “99” for the year digits). Press the
FEED key to decrease the year number.
b. Month - After you have set the correct year, press the ENTER key to
advance to the two digit Month position. Scroll through the numbers
corresponding to the month by pressing the LINE key. The month number
will increase by one each time the LINE key is pressed until it reaches a
value of “12”. Press the FEED key to decrease the month number.
c. Day - After you have set the correct month, press the ENTER key to advance
the cursor to the two digit Day position. Scroll through the numbers
corresponding to month date by pressing the LINE and FEED keys. The date
number will increase by one, each time the LINE key is pressed until it
reaches a value of “31”. Press the FEED key to decrease the day number.
d. Hour - After you have set the correct date, press the ENTER key to advance
the cursor to the two digit Hour position. Scroll through the numbers
corresponding to the hour (using a 24 hour clock) by pressing the LINE and
FEED keys. The hour number will increase by one each time the LINE key
is pressed until it reaches a value of “24”. Press the FEED key to decrease
the hour number.
e. Minute - After you have set the correct hour, press the ENTER key to
advance the cursor to the two digit Minute position. Scroll through the
numbers corresponding to the minutes by pressing the LINE and FEED keys.
The minute number will increase by one each time the LINE key is pressed
until it reaches a value of “60”. Press the FEED key to decrease the minute
number.