PN 9001098
Rev. A
2-17
SATO M-10e TT/DT Printers Service Manual
Section 2. Configuration
Ignore CR/LF
ignore cr/lf
yes no
This setting tells the printer to strip out all carriage return/line feed pairs (CR/LF) from the
data stream, including graphics and 2D bar codes. It is used primarily to maintain
compatibility with earlier models of SATO printers.
STEP PROCEDURE
1. Use the keys to step the cursor to either YES or NO.
2. Once the correct setting is selected, press ENTER to accept the setting
and advance to the Character Pitch display.
Character Pitch
character pitch
prop fixed
This setting allows you to set the default character pitch to either proprotional character
spacing or fixed character spacing. The default setting is PROP (proportional pitch YES)
STEP PROCEDURE
2. After you have set the last item press the ENTER key to advance to the
Ignore CR/LF selection.
LCD Panel —Advanced Mode
Set Calendar (Continued)
STEP PROCEDURE
1. Use the keys to step the cursor to the desired setting.
2. Once the desired setting is selected, press ENTER to accept the setting
and return to the Advanced Mode display.
To Exit the Advanced Mode, power the printer off, then back on.
To Next Page
Loading...
