SATO M-10e TT/DT Printers Service Manual
PN 9001098
Rev. A
2-18
Section 2. Configuration
STEP PROCEDURE
1. From the Advanced Mode press the ENTER key, then press the key to
switch to the Card Mode.
The Card Mode display indicates that the printer is in the Card Mode. To advance
to the Mem Select (CC1) press the ENTER key.
This selection determines which type of optional expanded memory will be
addressed as “CC1” in the command streams. The CARD selection specifies the
optional PCMCIA card as CC1 and the optional Expanded Flash ROM as CC2.
The MEMORY selection specifies the optional Expanded Flash ROM as CC1 and
the optional PCMCIA card as CC2.
2. Step the cursor to the desired selection (CARD or MEMORY) using the
cursor keys.
3. Once the cursor is positioned over the desired selection, press the ENTER key to
accept the selection and advance to the next screen.
LCD Panel — Card Mode
The Card Mode is entered from the Advanced Mode display. This selection allows the operator
to manage the Expanded Memory (PCMCIA Card or Internal Expanded Flash ROM).
card mode
Mem Select (cc1)
card memory
Mem Select (CC1)
This selection allows you to copy True Type fonts from the PCMCIA Memory card installed
in the Memory Card slot on the rear of the printer to the Option Flash ROM.
Card -> MemoryCopy
TrueTypeFont Y/N
card -> memorycopy
truetypefont y/n
STEP PROCEDURE
1. Use the keys to step the cursor to either YES copy or NO.
If Yes is selected, the printer will enter the Card Copy mode. If No is selected,
the display will advance to the Card to Memory SATO Font Copy mode.
2. Confirm your selection by stepping the cursor to the Yes selection. If No was
selected, the display will return to the previous selection.
3. Press the ENTER key to accept the setting. If Yes was selected, the Copy
process will start.
To Next Page
Loading...
