SATO M-10e TT/DT Printers Service Manual
PN 9001098
Rev. A
2-36
Section 2. Configuration
STEP PROCEDURE
1. Record all current dip switch positions, then place all switches in the OFF
position.
2. Place DSW2-4 in the ON or up position.
3. Press the LINE and FEED keys simultaneously while turning on the power.
Release the keys when the printer beeps. The following screen will appear
4. Place the DSW2-4 in the OFF position and the following screen will appear.
.
5. Press the ENTER key to enter the Clear Mode.
6. Use the keys to select NONE (Do not Clear), ALL (Clear All)
HEAD (Clear head counter only) or CUT (Clear cutter counter only)
LCD Panel — Maintenance Mode — Factory Mode
This function is used to clear counters and reset the printer’s firmware and is used after
upgrading the flash firmware or installing a new memory module.
Maintenance Mode
dipsw2-4 on>off
STEP PROCEDURE
4. When the printer has completed the reset process, the Default Setting
Completed display will appear. The printer is now in the default
configuration.
To exit the Default Setting Mode, power the printer off, then back on.
default setting
completed
LCD Panel — Default Setting Mode
Default Setting Mode
(Continued)
Factory mode
counter clear
none
To Next Page
Loading...
