Conditions That Trigger Paper End
142
Conditions That Trigger Paper End
The conditions that trigger paper end vary depending on the operation of the product, and the sensor
type selected.
If I-mark (reflective type) or Gap (transmissive type) is specified as the paper end sensor, then the
paper end is detected according to the following conditions.
You can select the sensor type for paper end in the [Printing] > [Advanced] > [Paper End] > [Sensor
Type] menu.
If [None] is specified as the paper end sensor, then the paper end is not detected.
Conditions That Trigger Paper End in the Feeding Operation
• When using I-mark for the paper-end sensor
A paper-end occurs if the no-paper condition persists even after the I-mark sensor still detects
the no-paper condition after 15 mm (0.59") has been fed.
(1) Paper end detection
(2) Paper end detection level (fixed)
(3) I-mark sensor waveform
• When using Gap for the paper-end sensor
A paper-end occurs if the no-paper condition persists even after the gap sensor still detects the
no-paper condition after the distance set as the detection distance has been fed.
(1) Paper end detection
To Next Page
Loading...