[Notifications]
262
If this function is enabled, the [Language] icon is added to the [Settings] menu screen as below. You
can directly access the display language setting screen.
[Notifications]
Set the function to notify when to clean and replace parts.
The setting items are as follows:
[Clean Printhead]
Notify when the print head needs to be cleaned.
The setting items are as follows:
[Clean Printhead]
Enable or disable the notification function about when the print head needs to be cleaned.
The options are as follows:
Enabled
Enable the notification function.
Disabled
Disable the notification function.
[Cleaning Interval]
Set the notification interval about when the print head needs to be cleaned.
You can change this setting if you have selected [Enabled] in the [Clean Printhead] menu.
The product shows the print distance as a set value. The setting range is from 10 to 1000 meters.
[Clean Counter]
Shows the current print distance.
[Change Printhead]
Notify when the print head needs to be replaced.
The setting items are as follows:
To Next Page
Loading...