Adjusting the Print Position
352
Adjusting the Print Position
Set the [Pitch] in the [Printing] > [Advanced] > [Adjustments] menu to adjust the print position.
• The above reference position (print position) is the stop position when the media
sensor type is set to Gap.
• You can adjust the print position during printing by registering the [Adjustments] menu
to the [Shortcut] menu in advance.
1.
When the product is in Online mode, press the button on the operator panel to
change to Offline mode.
2.
Press the button to show the [Settings] menu.
• Input the password if it is enabled.
To Next Page
Loading...