97
The USB interface is selected after connecting the USB cable to the computer and the product, and
powering on the product while the computer is turned on.
• If the product is powered on without installing the printer driver, Windows' Plug & Play
runs. When using the printer driver, do not power on the product while the USB cable is
connected until instructed in the procedure for installing the printer driver.
• We recommend a USB cable that is less than 5 m (16.4 feet) long.
LAN Interface Connection (Standard)
Connect the interface cable when the product is powered off.
Connect the LAN cable to the LAN connector (1) on the product.
The communication condition settings must be configured according to your network environment. Set
the IP address of the product.
The IP address of the product can be set through the product's [Interface] menu or the All-In-One Tool.
• To use the printer driver, the communication protocol must be set to Status4. (The
initial value of the communication protocol for the product's LAN interface is Status4
ENQ.)
NFC Interface Connection (Standard)
The NFC interface of the product supports a handover function that simplifies the Wi-Fi connection
setup with Android devices.
The handover function only performs the connection setup, such as the pairing and authentication with
NFC, and passes the actual interface to the more advanced Wi-Fi when communicating between NFC
supported devices.
In general, the pairing and authentication require some procedures to enter authentication information,
but the connection can be completed simply by holding the Android devices over the product while
using NFC.
Touch the NFC antenna (1) of the product with the NFC mark on the Android device.
To Next Page
Loading...