[Certificates]
286
[Start with]
Select the profile to be loaded at product startup.
Not available if no profile is registered.
The procedure to load the profile at product startup is as follows:
1.
Select the profile to be loaded at product startup using the / buttons.
2.
Press the button or the button to confirm.
[Service]
These are the setting items for service.
Strictly for SATO authorized service personnel use.
[Factory]
These are the setting items for factory.
Strictly for SATO authorized service personnel use.
[Certificates]
Install certificates used for Wi-Fi authentication and for HTTPS.
Available only if you have installed the USB memory.
• Be sure to perform a virus check on the USB memory before connecting it to the
product. SATO Corporation shall not be held responsible for any product malfunctions
caused by a virus spread via USB memory.
The setting items are as follows:
HTTPS
Installs the HTTPS certificates from the USB memory.
Wi-Fi Root CA
Installs the Wi-Fi Root CA certificates from the USB memory.
Wi-Fi Client
Installs the Wi-Fi client certificates from the USB memory.
Wi-Fi Private Key
Installs the Wi-Fi private key from the USB memory.
EAP-FAST PAC File
Installs the EAP-FAST PAC file from the USB memory.
The procedure to install the certificates and PAC files is as follows:
To Next Page
Loading...