SATO S84NX - Printing RFID Tag Errors

Printing RFID Tag Errors
382
Printing RFID Tag Errors
If the recorded data on a tag is incomplete due to writing on a defective tag, the product will print an
RFID tag error to the defective media. This function is to prevent the distribution of defective media
with a tag error.
When an RFID tag error occurs, the product prints a slash and the error message, such as "WRITE
TAG ERROR" or "TAG NOT FOUND". The position to print the message and slash is set using the
specified media size command <A1>.
For a write error such as "WRITE TAG ERROR", the product continues to print the first 16 or 32 bytes
of the write data.
The diagram below shows the message and slash printed on the position based on the media size
specified by the normal print.
• The following figures show an example of Opposite/Right-Hand Type.
WRITE TAG ERROR in RFID Write Command READ TAG ERROR in RFID Read Command
For other errors, the product prints the error
message accordingly.