293
[Clone]
Copy the current product settings and the installed data to the USB memory.
Available only if you have installed the USB memory.
• Be sure to perform a virus check on the USB memory before connecting it to the
product. SATO Corporation shall not be held responsible for any product malfunctions
caused by a virus spread via USB memory.
This function is useful to transfer the settings of a product you are replacing to continue using them in
a new product, or if you are setting up multiple products with the same settings.
The options are as follows:
Excl. LAN/Wi-Fi/IP/Bluetooth
Copy the product settings and data, excluding network information, to the USB memory. This is
useful when you set up multiple products, that are already connected to a network, with the same
settings.
Incl. LAN/Wi-Fi/Bluetooth
Copy the product settings and data, including network information (excluding the IP address), to
the USB memory. This is useful when you set up multiple products to be connected to the same
network with the same settings.
Incl. LAN/Wi-Fi/IP/Bluetooth
Copy the product settings and data, including network information (including the IP address), to
the USB memory. This is useful when transferring the settings of a product you are replacing to
continue using them in a new product.
• The product does not support the Bluetooth interface.
[Clone Notice Setting]
Enable or disable the clone notification.
By enabling this, a message prompting you to create a clone appears if the product's settings have
been changed.
Available only if you have connected the USB memory to the USB connector (Type A) on the back of
the product.
• Be sure to perform a virus check on the USB memory before connecting it to the
product. SATO Corporation shall not be held responsible for any product malfunctions
caused by a virus spread via USB memory.
The options are as follows:
Enabled
Enable the clone notification.
To Next Page
Loading...