[Imaging]
158
None
Do not backfeed.
After
After dispensing the label, backfeed the front part of the next label to the print head position.
Before
Before printing, backfeed the front part of the next media to the print head position.
Controled
When a signal is received from the applicator after dispensing a label, the leading edge of the
next label is back fed to the print head position.
• The selectable operations differ according to the print mode.
[Print Mode] [None] [After] [Before] [Controled]
[Continuous] Possible - - -
[Dispenser] - Possible Possible Possible
[Linerless] - - Possible -
[Dispense &
Print]
- Possible Possible -
[Darkness]
Specify the print darkness from 10 steps.
The setting range is from 1 to 10. 1 is the lightest and 10 is the darkest.
• To further fine tune the print darkness, set [Printing] > [Advanced] > [Adjustments] >
[Darkness Adjust].
[Imaging]
Set the print reference position in the vertical and horizontal directions.
The setting items are as follows:
Vertical
Set the print position in the vertical direction.
Set the correction value from the print reference position as "-" for the direction of the paper feed
and "+" for the direction opposite to the paper feed.
To Next Page
Loading...