155
Resolution S84NX S86NX
305 dpi (12 dots/mm) 4 to 14 ips (inches/sec) (101.6 to
355.6 mm/sec)
4 to 12 ips (inches/sec) (101.6 to
304.8 mm/sec)
609 dpi (24 dots/mm) 2 to 6 ips (inches/sec) (50.8 to
152.4 mm/sec)
-
• If [Enabled] is selected in the [Micro Label Print Mode] menu, the print speed has a
maximum of 4 ips (inches/second).
• Setting the print speed to a level that is too fast may affect the print quality.
[Sensor Type]
Set the sensor type for detecting the media.
The options are as follows:
None
Disable the media sensor.
Gap
Select when using gap type media. Use the transmissive type sensor.
I-Mark
Select when using I-mark type media. Use the reflective type sensor.
• If you have selected [Dispenser] or [Dispense & Print] in the [Print Mode] menu, only
[Gap] and [I-Mark] will be available.
• If you have selected [Linerless] in the [Print Mode] menu, only [None] will be available.
[Micro Label Print Mode]
Set the micro label print mode operation.
Micro Label Print Mode is a mode to provide high accuracy printing for small sized labels.
• The accuracy of Micro Label Print Mode is dependent on the usage conditions,
including quality of label production, print layout, and ribbon sizes.
The following conditions are recommended,
◦ Ribbon length: Less than 450 m
◦ Used media sensor: Gap sensor
• The improved accuracy provided by micro label print mode is for labels sizes of less
than the distance between the print head position and paper end sensor (incl. GAP).
• When the Micro Label Print Mode is enabled when print speed is 5 ips or above, the
print speed will be automatically reduced to 4 ips.
To Next Page
Loading...