351
Adjusting the Base Reference Point
About the Base Reference Point
The base reference point is the point at which one determines the print position and stop/dispensing
position.
The base reference point differs depending on the operation mode or media sensor you use.
Continuous Mode
I-mark Label Gap Label
(1) Feed direction
(2) Print and stop position
(1) Feed direction
(2) Print and stop position
Dispenser Mode/Dispense & Print Mode
I-mark Label Gap Label
(1) Feed direction
(2) Print and dispensing position
(1) Feed direction
(2) Print and dispensing position
To Next Page
Loading...