Connecting the Power Cord
78
Powering On/Off the Product
Connecting the Power Cord
• Do not power on or off the product, connect or disconnect the power cord while your
hands are wet. Doing so could cause an electric shock.
• Always connect the ground wire to a ground terminal. Electric shock could occur if you
do not.
• Make sure that the AC voltage of your region is in the range of AC 100 - 240 V, 50 -
60 Hz. If your local voltage is not in the stated range, contact your SATO reseller or
technical support.
• The attached power cord is designed exclusively for this product. Do not use it with
other devices.
1. Connect the power cord to the AC input terminal (1) at the rear of the product.
Take note of the orientation of the connector. Secure the product with one hand, and insert the
connector tightly.
2. Insert the power plug into an AC outlet.
* The shape of the power plug varies depending on the region in which it was purchased.
• This product is also designed for IT power distribution system with phase-to-phase
voltage 230 V.
To Next Page
Loading...