[RFID] (S84NX Only)
228
Home Position
Outputs a signal when [Backfeed] in the [Printing] menu is set to [Controled] and backfeed is
done.
Paper End/Ribbon End
Outputs a signal when the paper end or the ribbon end is detected.
Machine Error/RFID Error (If RFID mode is enabled) (S84NX only)
Outputs a signal when an error, such as cover open, head error, or communication error, is
detected.
Or, outputs a signal when an RFID system error occurs.
RFID error (If RFID mode is enabled) (S84NX only)
Outputs a signal when an RFID system error occurs.
RFID Tag Error (If RFID mode is enabled) (S84NX only)
Outputs a signal when an RFID tag error occurs.
BCR Error
Outputs a signal when a barcode reading/comparison error is detected.
AEP
Outputs a signal for AEP (Application Enabled Printing).
Unassigned
No signal is assigned.
[Signal State]
Select the signal state to assign.
Appears only if you have selected an item other than [Unassigned] or [AEP] in [Function].
The options vary depending on the function set in [Function].
If you have selected [Print Done] in [Function]:
• [TYPE1]
• [TYPE2]
• [TYPE3]
• [TYPE4]
If you have selected an item other than [Print Done] in [Function]:
• [Active Low]
• [Active High]
[RFID] (S84NX Only)
Set the RFID.
Appears only for the RFID model.
• To use the RFID option, use a firmware version that is later than 8.1.0.
To Next Page
Loading...