227
[Signal State]
Select the signal state to assign.
Appears only if you have selected an item other than [Unassigned] in [Function].
The options vary depending on the function set in [Function].
If you have selected [Label Near End] or [Feed] in [Function]:
• [Active Low]
• [Rising Edge]
If you have selected [Cancel], [Online/Offline] or [Dispense In] in [Function]:
• [Falling Edge]
• [Active High]
[Outputs]
Assign the output signals to the pin number.
Select the pin to assign the signal.
The available pins are as follows:
[PIN3]/[PIN4]/[PIN5]/[PIN6]/[PIN16]/[PIN17]/[PIN18]/[PIN19]
The setting items are as follows:
[Function]
Select the function to assign.
The options are as follows:
Paper End
Outputs a signal when the paper end is detected.
Ribbon End
Outputs a signal when the ribbon end is detected.
Machine Error
Outputs a signal when an error, such as a cover open, head error, or communication error is
detected.
Print Done
Outputs a signal when printing is complete.
Print Ready
Outputs a signal when the product is in Online mode and ready for printing.
Online
Outputs a signal when the product is in Online mode.
Data Present
Outputs a signal when print data is available.
Ribbon Near End
Outputs a signal when the ribbon near end is detected.
To Next Page
Loading...