403
Initializing the Product
Procedures for Initializing
Initialize the product's data and setting values.
• It is generally not necessary to perform the initialization. Doing so could change the
print conditions.
• You cannot recover the data and settings that are lost because of initialization. Before
doing an initialization, make a backup if needed. You can back up the product's data
and setting values by using the following function in the [Tools] menu.
◦ [Clone]: Copies the current data and settings to the USB memory. To recover
the data and setting values, use the USB memory to take the .pkg file that was
created, and then apply them to the product.
• The data that is initialized is the fonts and graphics registered in the product.
1.
If the product is in Online mode, press the button to go to Offline mode.
2.
Press the button to show the [Settings] menu.
To Next Page
Loading...