431
Initial ValueSetting Item
S84NX S86NX
Initialized by
User Reset/
Factory Reset
[Change Printhead]
[Change Printhead] [Disabled] Yes/Yes
[Printhead Interval] 100 km Yes/Yes
[Change Platen]
[Change Platen] [Disabled] Yes/Yes
[Platen Interval] 100 km Yes/Yes
[Change Belt(Gear Box)]
[Change Belt] [Disabled] Yes/Yes
[Belt Interval] 150 km Yes/Yes
[Change Belt(Ribbon)]
[Change Belt] [Disabled] Yes/Yes
[Belt Interval] 150 km Yes/Yes
[Sound]
[Error Sound] [Medium] Yes/Yes
[LCD Brightness] 7 No/Yes
[LED Indication] [Enabled] Yes/Yes
[Cover Open Sensor] [Enabled] Yes/Yes
[Show Total Count] [Disabled] Yes/Yes
[Password]
[Password Enable] [Disabled] No/Yes
[Install Security] [Disabled] No/Yes
[NFC Security] [None] Yes/Yes
[Tools] Menu
Initial values refer to the values set for the product when it was shipped from the factory. If you reset
the product, the values set in the product are initialized. The table below shows the initial value of each
setting item and whether it would be initialized.
To Next Page
Loading...