SATO S84NX - [Reset]

283
1.
Select the file type to print and press the button.
◦ buff/
The buffer data saved when you perform the [Buffer Dump].
◦ hexdump/
The received data created through [Hex Dump Mode].
2.
Select the file to print and press the button or button to perform the dump print.
• Printing the contents of the file may use a lot of media.
• When [Hex Dump Mode] is set to [Enabled], it may take some time before the files
appear.
[Reset]
Initialize the setting values and data saved on the product.
Press button to show the [Select] menu.
[Select]
Select the items to be initialized.
The items are as follows:
[Data]
Initialize the data saved on the product.
The data to be initialized are the fonts and graphics registered in the product.
When you select [Data], the confirmation screen appears.
Press the button to cancel or button to perform the initialization.
The product will reboot after the initialization.
• Normally, it is not necessary to perform the initialization. Doing so could change the
print conditions.
[Data & Settings]
Initialize the data and setting values on the product.
Select the setting items to be initialized.
The options are as follows:
User Reset
Initialize the data and setting values.
User Reset (-Interface)
Initialize the data and setting values that are not included in the [Interface] menu.