287
1. Save the certificate files to the USB thumb drive memory’s root folder.
Acceptable file extensions are as follows:
◦ .pem, .crt, .cer, .der for Root CA and client certificate in PEM or DER format
◦ .pfx and .p12 for client certificates in PKCS #12 format
◦ .prv and .key for private keys in PEM/PKCS#8 format
◦ .pac for PAC files
2. Insert the USB memory into the USB connector (Type A).
3. Go to the [Settings] > [Tools] > [Certificates] menu.
4. Select the certificate you want to install. Refer to the item description above.
5. Select the certificate file from the list.
[Barcode Checker]
Set the barcode check function.
By connecting a barcode checker to the product, you can check the barcodes after printing.
• This function is available only when the print mode is set to continuous mode.
• You cannot use this function with the S84NX RFID models.
• You cannot use this function in AEP mode.
The setting items are as follows:
[Test]
Set up the barcode checker.
The setting items are as follows:
[Reader Name]
Shows the barcode checker connected to the product.
[Reading Test]
Perform a test read with the connected barcode checker.
Available only if you have connected the barcode checker.
Set a label with barcodes within the scanning range of the barcode checker, and then press the
button to start reading.
If reading is successful, the code type and read data are displayed. The data is displayed only up to 23
bytes from the beginning.
If reading is unsuccessful, or the displayed results of the read are not correct, adjust the position of the
barcode checker. For details on how to use the barcode checker, refer to the manual that came with
the barcode checker.
[Interface]
Set the RS-232C interface usage.
To Next Page
Loading...