[Barcode Checker]
288
The options are as follows:
RS-232C
Use the RS-232C interface for communicating with computers.
RS-232C Reader
Select this when you connect a barcode checker with RS-232C interface connection for the
barcode check function.
• A [RS-232C Reader] will be available in the future for expanded functions. If you are
using a scanner manufactured by DATALOGIC, then you do not need to change this
setting from [RS-232C] (initial value).
• A message prompting you to restart the product will appear on the Online/Offline
screen if you have made any changes. In such a case, reboot the product to apply the
settings.
[Settings]
Set the barcode check function.
The setting items are as follows:
[Mode]
Select the check mode or disable the barcode check function.
Available only if you have selected [Continuous] in the [Print Mode] menu.
The options are as follows:
Disabled
Disable the barcode check function.
Readable
Check if the printed barcodes are readable.
To include barcodes that are not created by barcode commands (such as graphic data or
preprinted barcodes) as the target of the barcode readability check, select [Settings] in [Set No. of
Barcodes], and specify the number of barcodes per label in [Barcodes per Label].
Comparison
Check if the read results of the printed barcodes match the barcode data in the print data. This
mode is for barcodes created by barcode commands.
[Set No. of Barcodes]
Select the method to specify the number of barcodes per label.
Appears only if you have selected [Readable] in the [Mode] menu.
The options are as follows:
Command
Set barcodes created by barcode commands as the target of the barcode readability check.
To Next Page
Loading...