[SDPL]
250
[STCL]
This setting menu is to use SEPL as a printer command.
Contact your SATO sales representative for more information about the use of STCL command.
[SDPL]
To use SDPL as a printer command, set the following items:
• [Format Attribute], [Pause Mode], [1 Byte Codepage], [SDPL Measure Unit], [Scalable
Font Style], [Feedback Character], [SOH Commands] and [Module Selection] are
available only if [Settings] is selected for the corresponding setting item under the
[Prioritize] menu.
[Control Code]
Set the control code.
The setting items are as follows:
[Code Type]
Set the type of the control code.
The options are as follows:
• [Standard]
• [Alternate 1]
• [Alternate 2]
• [Custom]
[SOH]
Set the SOH code.
You can change this if you have selected [Custom] in the [Code Type] menu.
The setting range is from 00 to ff (hexadecimal).
[STX]
Set the STX code.
You can change this if you have selected [Custom] in the [Code Type] menu.
The setting range is from 00 to ff (hexadecimal).
[CR]
Set the CR code.
You can change this if you have selected [Custom] in the [Code Type] menu.
The setting range is from 00 to ff (hexadecimal).
[CNTBY]
Set the CNTBY code.
To Next Page
Loading...