USB Interface Connection (Standard)
96
How to connect the host computer and the applicator to the product
• Do not connect or disconnect the interface cables (or use a switch box) while power
is supplied to either the product or computer. This may cause damage to the interface
circuitry in the product or computer and is not covered by warranty.
• Check the orientation of the connector before you make the connection.
1. Make sure that the product, host computer and applicator are powered off.
◦ Set the power switch of the product to the "O" position.
2. Connect the product to a host computer with one or more of the available interface connections.
3. Connect the applicator cable from the EXT connector of the product to the applicator.
USB Interface Connection (Standard)
Connect the interface cable when the product is powered off.
Connect the USB cable to the USB connector (Type B) (1) of the product.
To Next Page
Loading...