Product Memory and USB Memory
70
Product Memory and USB Memory
The memory of the user area of the product is a maximum of 576 MB.
However, you cannot use the whole memory of the user area, because this area is also used for the
log data and HEX dump functions.
USB memory can be connected to the product. There is no capacity limit for USB memory.
There are two USB connectors (type A) on the back and one side of the product (left side when
facing the Standard/Left-hand type product and right side when facing the Opposite/Right-hand type
product). USB memory can be connected to either connector.
What you can do with this product while it is connected to USB memory is as follows:
• Get the HEX dump data
• Install certificates used for Wi-Fi authentication and for HTTPS
• Get the barcode check log data
• Create clone data (copy the product's settings information)
• Get the support information
• Be sure to perform a virus check on the USB memory before connecting it to the
product. SATO Corporation shall not be held responsible for any product malfunctions
caused by a virus spread via USB memory.
• When using the connector on the side of the product, be sure to insert and remove the
USB memory stick perpendicular to the connector.
• The product does not support USB memory with security functions such as fingerprint
authentications.
• The product does not support connection through the USB HUB.
• Use USB memories that are formatted to FAT32.
• The size of the USB memory that can be connected to the side of the product is as
follows:
◦ Length: under 68 mm (2.68") (excludes the metal part of the connector)
◦ Width: under 27.6 mm (1.09")
◦ Thickness: under 8.6 mm (0.34")
To Next Page
Loading...