Manually Setting the Print Mode
90
Manually Setting the Print Mode
You can change the print mode of the product according to its usage.
The product has the following print modes:
[Continuous]
Prints the specified number of media. The media remains in position for printing at all times.
[Dispenser]
Peels the liner from the printed label as the label is fed to the media discharge outlet. Once the
printed label has been removed from the product for application, the next label will retract and
position itself for printing.
[Linerless]
When specialized hardware is installed on the external equipment, then linerless labels are fed
and printed.
[Dispense & Print]
The printed label advances to the dispensing position while the next data is printed.
If the next data is not available, it is fed to the dispensing position without printing, then backfeed
and regular dispensing are done.
In this mode, when printing is stopped, such as due to a cancel operation during printing of labels,
feed and eject the labels that have been finished printing part way before restarting printing.
Restarting without doing this would cause an error.
Change the print mode according to the following procedure:
1.
Press the button or button in Online mode.
The product changes to Offline mode.
To Next Page
Loading...